Royce Innovator 'Cool' ROM Knee Brace
The quickest and most innovative design
Our Innovator Cool model has a softgood designed for greater breathability and patient comfort in warmer climates.
Performance Benefits
- Quick, easy and accurate settings - simply press, rotate and release
- Locks quickly at 0, 10, 20, 30, 45, 60, 75 and 90 degrees
- Durable, lightweight ergonomic design
- Available in 3 models and 2 lengths to facilitate excellent fit
- Easy-to-see range of motion stops
- Low-profile hinge, no exposed metal edges to scrape, catch or snag
- Wide variety of choices - 10 flexion settings - 8 extensions settings
Indications
The Innovator Cool post-op knee brace is indicated for ligament and fracture-related surgeries and when controlled range of motion is necessary.
Short or Long?
The Royce Innovator Knee Brace is available in a short model (61cm) and a long model (71cm)
Sizing Chart
Measure thigh circumference 6" above mid-patella
| Product No. | Foam | Size | Thigh Circ. | Length |
| 403100 | Cool | Regular | Up to 27" / 68cm | SHORT: 24" / 61cm |
| 403102 | Cool | X-Large | 27 - 35" / 68 - 88cm | SHORT: 24" / 61cm |
| 403101 | Cool | Regular | Up to 27" / 68cm | LONG: 28" / 71cm |
| 403203 | Cool | X-Large | 27 - 35" / 68 - 88cm | LONG: 28" / 71cm |
Replacement Foam / Accessories
| Product No. | Foam | Accessories | Buy |
| 403175 | Cool | Replacement softgood / REGULAR | ![]() |
| 403176 | Cool | Replacement softgood / X-LARGE | ![]() |
FITTING INSTRUCTIONS

- 1. To assess length, locate the hinge pivot center slightly above the knee joint midline.
- 2. To increase length of the strut, rotate length adjustment lever one-half turn (180 degrees) to the unlocked position.
- 3. Position and alignment marks are provided on the metal strut. When desired side strut length has been achieved, rotate length adjustment lever back to the locked position. Strut is preset at 23" (58 cm). Do this adjustment for both hinges. To decrease length of strut, the extension bars may be completely removed t0 minimize InnovatorT DLX length to 17" (43 cm).
- 4. Ensure the patella remains exposed and that the medial and lateral hinges are aligned just above mid-patella.
- 5. After length is determined, trim softgood padding as necessary. Straps may also be trimmed as necessary.
- 6. Secure and fasten all straps, starting with the two straps closest to the knee.
- 7. Apply anti-migration (gastroc) strap as required(optional).
- 8. To adjust range of motion, press the flexion or extension button and rotate until the desired degree of flexion or extension appears through the indicator window.
- 9. To set the hinge lock, determine the desired lock angle. Align the setting arrow on the hinge to the appropriate angle as marked on the lower side bar sleeve. Slide the drop lock button to secure the angle of the hinge.
- 10. To enforce compliance, loop and secure the enclosed lock ties through the hole in the flexion and extension buttons to limit range of motion adjustment.
- 11. The side bars may be bent to fit individual anatomy. Side bars must be bent with final length adjustments completed and with metal struts installed in the plastic sleeves. Bend with bending irons.
- 12. To remove the Innovator DLX, unfasten the straps and open the foam pads. The brace can then be removed and reapplied as a single unit.














